Make a Design Wall Without Duct Tape

Since my daughter was home for the fall, I moved my sewing space into our bedroom. That meant creating a new design wall. Rather than attaching it to the wall like I did in her room, I made a portable one.

quilt design wall

With the previous one I used duct tape to attach the insulation boards together and created one large design wall. I also used duct tape to attach the flannel to the back of the insulation boards.

I skipped the tape and used silk pins for this one.

And, I made three separate design walls which I hung with pants hangers. You don’t have to use yellow flannel, but this is what I had in my stash.

SUPPLIES:

  • One (1) insulation board, 1/2 inch thick, 4 feet by 8 feet
  • Flannel
  • Three Flat Wood Pants Hanger

HOW TO:

  • Measure the insulation board into thirds. Mine was 96″ so 32″ each.
  • Draw a line along each 32″ line.

measure the insulation board

  • Score the insulation board with a knife:
  • Cut with a knife or a old rotary cutter.

cut the insulation board

  • Cut the flannel.

I cut mine about 2 1/4″ larger than the insulation.

52″ by 36.5″ (it doesn’t have be this exact size)

cut the flannel

  • Wrap the flannel around the insulation board:

pin the insulation board

  • Use silk pins to hold in place. Here’s where you don’t have to use duct tape which I used in my large design wall.
  • Miter all the corners and pin at an angle so that the pin doesn’t go through the front.

miter the corners

  • Attach cup hooks to the hall.

I used chalk to mark the level line.

cup hooks

  • Attach Pants Hanger to the insulation board and hang it:

attach pants hanger

I only hung two of the insulation boards and put the other one in the closet.

This was the perfect solution for me,

Wanda

Design Wall.

The Design Wall is now up!

IMG_2396

I first taped the two insulation boards together. I used duct tape:

IMG_2390

I ironed and pressed the flannel (no photo of that). I then pinned the flannel to the insulation boards using silk pins:

IMG_2394

I also used duct tape to hold the corners on the back (no photo).

We — a two-person job here — installed the design board to the wall, using screws. We made sure to install the screws where the studs were located. We are not home improvement experts by any means. We had some trouble at first because the screw caught the fabric, twisting it as it went into the insulation board. We made it work in the end.

IMG_2395

Another shot of the finished project:

IMG_2398

Again, thanks to Sew Katie Did for the inspiration.